Dry ice, abrasive, or both
Dry ice blasting cleans by sublimation: the dry ice turns from solid to gas when it hits the surface, removing contaminants, coatings and residues. The IBIX Twin 25 Hybrid Dry Ice System pairs that with a second hopper for abrasive, so one transportable unit handles precise cleaning on production equipment and heavier removal on coatings and rust.
Dry ice only
Precise cleaning with no blast media residue. Suited to injection and rotomolding molds, conveyor belts and sensitive equipment on industrial production lines.
Dry ice + abrasive
With sodium bicarbonate: tougher contaminants and faster cleaning with minimal abrasion, including cured pigments on industrial molds and dirt or limescale in food and other high-hygiene industries. With a mineral abrasive such as garnet: tough coatings, deep rust and industrial finish prep, with less secondary waste.
Abrasive only
Run the same unit with blast media alone when the job calls for surface prep without dry ice.
Switch modes at the gun
A selector on the gun changes mode while you work. Mixture control sets the proportion of dry ice to abrasive for each job.
Request a demoWhere it fits
Injection and rotomolding molds
Dry ice only for precise cleaning with no blast media residue. Add sodium bicarbonate for cured pigments and residues on industrial molds.
Conveyors and production lines
Conveyor belts and sensitive equipment on industrial production lines, plus dirt, limescale and contaminants in food and other high-hygiene industries.
Plant maintenance and degreasing
Dry ice with sodium bicarbonate removes grease, limescale and residues from stainless steel, mixers and plant components. No water, no chemical cleaners.
IBIX Twin 25 Hybrid Dry Ice System
- Power supply: 110 V / 60 Hz
- Weight: 157.1 lb, gun included
- Two hoppers, about 2.9 gal (11 L) each
- Air supply: about 124 CFM (3,500 L/min)
- Dry ice consumption: 88.2 lb/h